On all 4s

Assembly has begun

OOPS! I forgot to add these bars before paint!

Radius rods, A-arms, Tie Rods, Spindles and Rear Carriers are back from the powder coaters

Maybe start assembly tomorrow!!!

primed and ready for some spot painting

WELDING, WELDING, WELDING!!! Bout done welding though :)

Seat tabs are DONE!!!! Seats are in and now out for a while :)

Fitting seats. They will sit about 1" higher than pictured.

Ready to fit the seats, then weld everything up. THEN, the fun begins.

Spindles are done too!!!

Rear carriers are FINALLY done!!!!!!!

Lookin pretty bare. Almost time to remove the engine and trans and start welding...alot of welding!

Trans mounts are done

This is a must! Rollpin or cotter pin added to prevent the lower bolt on the kingpin from backing out

Steering is complete.

Making tabs and stuff is what is taking so damn long

rear is TOTALLY BUILT!!! Torn down now for welding

I changed the front shock mounts, upper and lower, and caster to 8*

Its lookin a little different than the old car. Wheel base is now 123.5"

16" from frame to the ground @ 6" negative travel in rear and 9" in the front

total of 21" travel up front

Attaching the a-arms and shock (Mike, it is only 80" wide in the front)

Right rear is built!

upper shock mount

rear carrier just needs some boxing and welding

that is 18" of travel

24* axle angle in the rear

upper inboard link needed then rear mock up is DONE!